## Estimate the maximum stress in the wire at critical point B.

1.A round wire helical-coil tension spring has end loops of the type shown in Figures 14.7(a) and (b). The wire diameter of the spring is 0.042 inch, and the mean coil radius is 0.28 inch. Pertinent end-loop dimensions are riA 0.25 inch and riB 0.094 inch. An applied axial static tension force of F 5.0 lb is to be applied to the spring.

a. Estimate the maximum stress in the wire at critical point A.

b. Estimate the maximum stress in the wire at critical point B.

c. If the spring wire is ASTM A227 material, and a safety factor of 1.25 is desired, would the stresses at critical points A and B be acceptable?

### Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

### Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

### calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….