## Find the torque required to drive a 16-mm single-start square thread power screw with a 2 mm pitch.

1. Repeat problem 12-7 if everything remains the same except that the power screw has double square threads.

2.A 40-mm rotating power screw with triple square threads has a pitch of . The screw is to be used to lift a 22 kN load at a speed of 4 m/min. Friction coefficients for both the collar and threads have been determined to be . The mean thrust collar friction diameter is 70 mm. Determine the power required to drive the assembly.

3. Find the torque required to drive a 16-mm single-start square thread power screw with a 2 mm pitch. The load to be lifter is 3.6 kN. The collar has a mean friction diameter of 25 mm, and the coefficients of collar and thread friction are mc = 0.12 .

### Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

### Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

### calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….