Use the short line model to find the voltage and power at the sending end and the voltage regulation and efficiency when the line is supply-ing a three-phase load of 381 MVA at 0.8 power factor lagging at 220 kV.

A 220-kV, three-phase transmission line is 40 km long. The resistance per phase is 0.15 f2 per km and the inductance per phase is 1.3263 mFl per km. The shunt capacitance is negligible. Use the short line model to find the voltage and power at the sending end and the voltage regulation and efficiency when the line is supply-ing a three-phase load of 381 MVA at 0.8 power factor lagging at 220 kV.

Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….