## What type of lubrication should be used for this application?

1.A five-strand no. 40 precision roller chain is being proposed to transmit power from a 21-tooth driving sprocket that rotates at 1200 rpm. The driven sprocket is to rotate at onequarter the speed of the driving sprocket. Do the following:

a. Determine the limiting horsepower that can be transmitted by this drive, and state the governing failure mode.

b. Find the tension in the chain.

c. What chain length should be used if a center distance of approximately 20 inches is desired?

d. Does the 20-inch center distance lie within the recommended range for this application?

e. What type of lubrication should be used for this application?

### Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

### Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

### calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….