## calculate the tooth bending stress at the tension-side root fillet of the driving pinion.

1. A 10-pitch 20 full-depth involute gearset, with and face width of 1.25 inches, is being proposed to provide a 2:1 speed reduction for a conveyor drive unit. The 18- tooth pinion is to be driven by a 15-hp, 1725-rpm electric motor operating steadily at full-rated power. A very long life is desired for this gearset, and a reliability of 99 percent is required. Do the following:

a. Using the AGMA refined approach, calculate the tooth bending stress at the tension-side root fillet of the driving pinion.

b. Repeat (a) for the tension-side root fillet of the driven gear.

c. If the proposed material for both gears is AISI 4620 through-hardened to BHN 207, estimate the existing safety factor at the tension-side root fillet of whichever gear is more critical, based on tooth bending fatigue.

### Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

### Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

### calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….