## Determine the following, and where possible, show each feature on a simple scale drawing of the gear mesh.

1.Except for a 3:1 speed decrease.

2. A proposed straight full-depth spur gear mesh is to consist of a 21-tooth pinion driving a 28-tooth gear. The proposed diametral pitch is to be 3, and the pressure angle is 20. Determine the following, and where possible, show each feature on a simple scale drawing of the gear mesh.

a. Pitch circle for the pinion.

b. Pitch circle for the gear.

c. Pressure angle .

d. Base circle for the pinion.

e. Base circle for the gear.

f. Addendum circle for the pinion .

g. Dedendum circle for the pinion.

h. Addendum circle for the gear.

i. Dedendum circle for the gear.

j. Circular pitch k. Tooth thickness.

k. One typical pinion tooth.

l. One typical gear tooth.

m. Length of action.

n. Base pitch.

o. Profile contact ratio .

### Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

### Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

### calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….